Filter
Top Products
7-9
Setup Menus
Reset Terminal
This will reset the current terminal emulation mode.
New Connection...
Factory default: Serial, Com 1
This will display a dialog box which enables you to make a serial or network host
connection.
The Type option specifies whether a serial or network connection is to be made.
Clicking the arrow button will display a drop-down list box containing all the
possible settings.
The Services option specifies the port or network host node which TeemTalk is to
communicate with. This is a text box with an associated drop-down list box. You can
either make a selection from the list box or enter a valid host name or internet address
in the text box.
Making A Serial Host Connection
To connect to a serial host, select Serial in the Type list box (default), then select the
Com port required in the Services list box. Click the Configure... button to display
the Serial Settings dialog box and make sure the settings match that of the host.
Click OK then click Connect.
Note: These options are described in the Serial Settings section
later in this chapter and only apply when the connection
type is set to Serial.