Filter
Top Products
Xerox 490/980 Color Continuous Feed Printing System Basic Operation
Printer Operator Guide 2-21
9. If the LED is not aligned, adjust the position of the ROF LED by changing the values of the
SENSOR position as shown in the graphic from step 7. Each increment of the slider moves
the ROF LED 0.02 inch (0.5 mm). To get the screen to refresh after moving the slider, go to
the MARK screen and then back to the Sensor screen.
10. Select [Settings] on the Feeder unit panel to enable the new position.
11. Check the ROF LED once again to insure it is in the middle of the pin hole.
12. To ensure proper operation, run test jobs. If intermittent fault codes involving the ROF
sensor occur, recheck the position of the ROF sensor and ensure the paper is the correct
type and the pinholes are punched out.
13. If error code B2-C5 occurs, refer to Chapter 3 on how to adjust the mark reading position.
14. If the error code B2-C6 occurs, notify your local Xerox service representative.
Caution
In the following step, ensure that the Feeder Front Door is closed before starting the job.