Filter
Top Products
4-80
ENG
CRANKSHAFT
NOTE:
CAUTION:
Recommended lubricant
Engine oil
3. Install:
Sbig end bearings
1
Sconnecting rods
2
Sconnecting rod caps
3
(onto the crankshaft pins)
SAlign the projections on the big end bearings
with the notches in the connecting rods and
connecting rod caps.
SBe sure to reinstall each big end bearing in its
original place.
SMake sure that the “Y” marks
a
on the con-
necting rods face towards the left side of the
crankshaft.
SMake sure that the characters
b
on both the
connecting rod and connecting rod cap are
aligned.
4. Align:
Sbolt heads
1
(with the connecting rod caps)
5. Tighten:
Sconnecting rod nuts
Connecting rod nuts
36 Nm (3.6 mSkg)
SWhen tightening the connecting rod nuts,
be sure to use an F-type torque wrench.
SWithout pausing, tighten the connecting
rod nuts to the specified torque. Apply con-
tinuous torque between 2.0 and 3.6 mSkg.
Once you reach 2.0 mSkg DO NOT STOP
TIGHTENING unitl the specified torque is
reached. If the tightening is interrupted be-
tween 2.0 and 3.6 mSkg, loosen the con-
necting rod nut to less than 2.0 mSkg and
start again.