Filter
Top Products
6-28
CHAS
FRONT AND REAR BRAKES
WARNING
CAUTION:
WARNING
CAUTION:
EAS00610
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
Scopper washers (New)
1
Sbrake hose
2
Union bolt
3
30 Nm (3.0 mSkg)
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
“CABLE ROUTING”.
When installing the brake hose onto the
brake master cylinder make sure that the
brake pipe touches the projection
a
as
shown.
2. Fill:
Sbrake fluid reservoir
Recommended brake fluid
DOT 4
SUse only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
SRefill with the same type of brake fluid that
is already in the system. Mixing brake
fluids may result in a harmful chemical
reaction, leading to poor brake perfor-
mance.
SWhen refilling, be careful that water does
not enter the reservoir. Water will signifi-
cantly lower the boiling point of the brake
fluid and could cause vapor lock.
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.