Filter
Top Products
5-6
CARB
CARBURETORS
NOTE:
NOTE:
EAS00489
2. Measure:
Sfloat height
a
Out of specification ! Adjust.
Float height
21.3 X 23.3 mm
a. Hold the carburetor upside down.
b. Measure the distance from the mating sur-
face of the float chamber (with the gasket re-
moved) to the top of the float.
The float arm should rest on the needle valve
without depressing it.
c. If the float height is not within specification,
inspect the needle valve seat and needle
valve.
d. If either the needle valve seat or needle valve
is worn, replace them both.
e. If both the needle valve seat and needle
valve are fine, adjust the float height by bend-
ing the float tang
1
.
f. Check the float height again.
3. Install:
Spiston valve
Spiston valve spring
Svacuum chamber cover
4. Install:
Sconnecting bracket
After installing the connecting bracket, check
that the throttle cable lever and starter plunger
link operate smoothly.