Filter
Top Products
6-39
CHAS
FRONT AND REAR BRAKES
WARNING
New
30 Nm (3.0 mSkg)
WARNING
CAUTION:
40 Nm (4.0 mSkg)
7 Nm (7.0 mSkg)
EAS00642
ASSEMBLING AND INSTALLING THE REAR
BRAKE CALIPER
SBefore installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
SNever use solvents on internal brake com-
ponents as they will cause the piston seals
to swell and distort.
SWhenever a brake caliper is disassembled,
replace the brake caliper piston seals.
Recommended brake fluid
DOT 4
1. Install:
Sbrake caliper
1
(temporarily)
Scopper washers
Sbrake hose
2
Sunion bolt
3
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
“CABLE ROUTING”.
When installing the brake hose onto the
brake caliper
1
, make sure that the brake
pipe
a
touches the projection
b
on the
brake caliper.
2. Remove:
Sbrake caliper
3. Install:
Sbrake pads
Sbrake pad springs
Sbrake caliper
Sbrake hose holder
Refer to “REPLACING THE REAR BRAKE
PADS”.