Filter
Top Products
6-17
CHAS
FRONT AND REAR BRAKES
NOTE:
NOTE:
3. Remove:
Sbrake pads
7
4. Measure:
Sbrake pad wear limit
a
Out of specification ! Replace the brake
pads as a set.
Brake pad wear limit
0.5 mm
5. Install:
Sbrake pads
Sbrake pad spring
Always install new brake pads, and a brake pad
spring as a set.
a. Connect a clear plastic hose
1
tightly to the
bleed screw
2
. Put the other end of the hose
into an open container.
b. Loosen the bleed screw and push the brake
caliper pistons into the brake caliper with
your finger.
c. Tighten the bleed screw.
Bleed screw
6 Nm (0.6 mSkg)
d. Install new brake pads and a new brake pad
spring.
The arrow
a
on the brake pad spring must point
in the direction of disc rotation.