Filter
Top Products
6-54
CHAS
HANDLEBAR
WARNING
WARNING
CAUTION:
NOTE:
3. Install:
Shandlebar grip
a. Apply a light coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
EAS00671
INSTALLING THE HANDLEBAR
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
2. Install:
Shandlebar
1
Supper handlebar holders
2
Upper handlebar holder bolt
23 Nm (2.3 mSkg)
SFirst, tighten the bolts on the front side of
the handlebar holder, then on the rear side.
STurn the handlebar all the way to the left
and right. If there is any contact with the
fuel tank, adjust the handlebar position.
SThe upper handlebar holders should be
installed with the arrows
a
facing forward
A
.
SAlign the match marks
b
on the handlebar
with the upper surface of the lower handlebar
holders.