Filter
Top Products
6-18
CHAS
FRONT AND REAR BRAKES
NOTE:
6. Install:
Sbrake pad pins
Sbrake pad clips
Sbrake caliper
Brake caliper bolt
40 Nm (4.0 mSkg)
7. Check:
Sbrake fluid level
Below the minimum level mark
a
! Add the
recommended brake fluid to the proper level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL” in chapter 3.
8. Check:
Sbrake lever operation
Soft or spongy feeling ! Bleed the brake
system.
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM” in chapter 3.
EAS00583
REPLACING THE REAR BRAKE PADS
When replacing the brake pads, it is not neces-
sary to disconnect the brake hose or disas-
semble the brake caliper.
1. Remove:
Sbrake caliper
1
2. Remove:
Sbrake pad cover
1
Sbrake pad clips
2
Sbrake pad pins
3
Sbrake pad spring
4
3. Remove:
Sbrake pads
5
(along with the brake pad shims)
4. Measure:
Sbrake pad wear limit
a
Out of specification ! Replace the brake
pads as a set.
Brake pad wear limit
0.5 mm