Filter
Top Products
3-26
CHK
ADJ
ADJUSTING THE REAR BRAKE/
CHECKING THE BRAKE FLUID LEVEL
A B
WARNING
CAUTION:
NOTE:
WARNING
EAS00110
c. Tighten the locknut
1
to specification.
Locknut
18 Nm (1.8 mSkg)
A soft or spongy feeling in the brake pedal
can indicate the presence of air in the brake
system. Before the vehicle is operated, the
air must be removed by bleeding the brake
system. Air in the brake system will consid-
erably reduce braking performance and
could result in loss of control and possibly
an accident. Therefore, inspect and, if nec-
essary, bleed the brake system.
After adjusting the brake pedal position,
make sure that there is no brake drag.
3. Adjust:
Srear brake light switch
Refer to “ADJUSTING THE REAR BRAKE
LIGHT SWITCH”.
EAS00115
CHECKING THE BRAKE FLUID LEVEL
1. Stand the motorcycle on a level surface.
SPlace the motorcycle on a suitable stand.
SMake sure that the motorcycle is upright.
2. Check:
Sbrake fluid level
Below the minimum level mark
a
! Add the
recommended brake fluid to the proper level.
Recommended brake fluid
DOT 4
A
Front brake
B
Rear brake
SUse only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
SRefill with the same type of brake fluid that
is already in the system. Mixing brake
fluids may result in a harmful chemical
reaction, leading to poor brake perfor-
mance.