Filter
Top Products
AI2524 Router Card User’s Manual
TOC-8 August 1997
2524UM
Substitute Addresses in a Local X.25 Rout ..................................................12-39
Configure XOT Alternate Destinations .........................................................12-39
Configure CMNS Routing ..........................................................................................12-40
Enable CMNS on an Interface.......................................................................12-40
Specify a CMNS Static Map of Addresses....................................................12-41
Example: CMNS Configured for X.121 and MAC Addresses ......................12-41
Example: CMNS Switched over a PDN ........................................................12-42
Example: CMNS Switched over Leased Lines..............................................12-43
Create X.29 Access Lists ............................................................................................12-45
Create an Access List.....................................................................................12-46
Example: X.29 Access List............................................................................12-46
Apply an Access List to a Line......................................................................12-47
Create an X.29 Profile Script ......................................................................................12-47
Example: X.29 Profile Script.........................................................................12-47
Configure LAPB .........................................................................................................12-48
Configure a LAPB Datagram Transport........................................................12-48
Example: Typical LAPB Configuration ........................................................12-49
Modify LAPB Protocol Parameters...............................................................12-49
Configure LAPB Priority and Custom Queuing............................................12-52
Configure Transparent Bridging over Multiprotocol LAPB .........................12-53
Monitor and Maintain LAPB and X.25 .........................................................12-53
Example: Transparent Bridging for Multiprotocol LAPB Encapsulation .....12-54
Example: X.25 Configured to Allow Ping Support over Multiple Lines ......12-54
Example: Booting from a Network Server over X.25 ...................................12-56
Chapter 13: AI2524 Frame Relay Configuration Steps.........................................13-1
Introduction.................................................................................................................13-1
Frame Relay Hardware Configuration........................................................................13-1
Frame Relay Configuration Task List.........................................................................13-2
Enable Frame Relay Encapsulation on an Interface ...................................................13-2
Examples: IETF Encapsulation......................................................................13-3
Configure Dynamic or Static Address Mapping .........................................................13-3
Configure Dynamic Mapping ........................................................................13-3
Configure Static Mapping ..............................................................................13-3
Examples: Static Address Mapping ...............................................................13-4
Configure the LMI ......................................................................................................13-5
Allow LMI Autosense to Operate..................................................................13-5
The LMI Autosense Process ..........................................................................13-5
Configuring LMI Autosense..........................................................................13-6
Explicitly Configure the LMI ........................................................................13-6
Configure Frame Relay Switched Virtual Circuits.....................................................13-8
Configure SVCs on a Physical Interface .......................................................13-8
Example: SVCs on an Interfac .....................................................................13-9
Configure SVCs on a Subinterface (optional) ...............................................13-9
Example: SVCs on a Subinterface.................................................................13-10
Configure a Map Class...................................................................................13-11
Configure a Map Group with E.164 or X.121 Addresses..............................13-12
Associate the Map Class with Static Protocol Address Maps.......................13-12