Filter
Top Products
Chapter 5: Using AutoInstall
August 1997 Page 5-21
2524UM
Note: If any problems exist with the configuration file pointed to
in NVRAM, or if the ignore NVRAM bit is set in th
configuration register, the router enters the streamlined
setup command facility. Refer to Use the Streamlined
Setup Facility, for more information.
This example shows how to use the setup command facility to config-
ure interface serial 0 and to add ARAP and IP/IPX PPP support on the
asynchronous interfaces:
Router# setup
---System Configuration Dialog---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Continue with configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
Interface IP-Address OK? Method Status Protocol
Ethernet0 172.16.72.2 YES manual up up
Serial0 unassigned YES not set down down
Serial1 172.16.72.2 YES not set up up
Configuring global parameters:
Enter host name [Router]:
The enable secret is a one-way cryptographic secret used instead of the enable
password when it exists.
Enter enable secret [<Use current secret>]:
The enable password is used when there is no enable secret and when using older
software and some boot images.
Enter enable password [ww]:
Enter virtual terminal password [ww]:
Configure SNMP Network Management? [yes]:
Community string [public]:
Configure DECnet? [no]:
Configure AppleTalk? [yes]:
Multizone networks? [no]: yes
Configure IPX? [yes]:
Configure IP? [yes]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [15]: