Filter
Top Products
AI2524 Router Card User’s Manual
Page 7-22 August 1997
2524UM
2. Copy the system image from Flash memory to a TFTP server.
copy flash tftp
3. When prompted, enter the IP address or domain name of the TFTP
server.
{
ip-address
|
name
}
4. When prompted, enter the filename of the system image in Flash
memory.
filename
This example uses the
show flash all
command to learn the
name of the system image file and the
copy flash tftp
command
to copy the system image to a TFTP server. The name of the system
image file (xk09140z) is listed near the end of the
show flash all
output.
Router# show flash all
2048K bytes of flash memory on embedded flash (in XX).
ROM socket code bytes name
0 U42 89BD 0x40000 INTEL 28F020
1 U44 89BD 0x40000 INTEL 28F020
2 U46 89BD 0x40000 INTEL 28F020
3 U48 89BD 0x40000 INTEL 28F020
4 U41 89BD 0x40000 INTEL 28F020
5 U43 89BD 0x40000 INTEL 28F020
6 U45 89BD 0x40000 INTEL 28F020
7 U47 89BD 0x40000 INTEL 28F020
security jumper(12V) is installed,
flash memory is programmable.
file offset length name
0 0x40 1204637 xk09140z
[903848/2097152 bytes free]
Router# copy flash tftp
IP address of remote host [255.255.255.255]? 101.2.13.110
filename to write on tftp host? xk09140z
writing xk09140z !!!!...
successful tftp write.
Router#
The exclamation point (
!
) indicates that the copy process is taking
place. Each exclamation point
!
) indicates that ten packets have been
transferred successfully. To stop the copy process, press <Ctrl-^>.
Once you have configured Flash memory, you might want to configure
the system (using th
configure terminal
command) with the