Filter
Top Products
AI2524 Router Card User’s Manual
Page 12-26 August 1997
2524UM
Configure X.25 User Facilities
The X.25 software provides commands to support X.25 user facilities
(options specified by the creators of the X.25 Recommendation) that
allow you to implement features such as accounting, user identifica-
tion, and flow control negotiation. You can choose to configure facil-
ities on a per-map basis or on a per-interface basis. In the following
list, the
x25 map
commands configure facilities on a per-map basis;
the
x25 facility
commands specify the values sent for all encap-
sulation calls originated by the interface. Routed calls are not affected
by the facilities specified for the outgoing interface.
To set the supported X.25 user facilities, perform one or more of these
tasks in interface configuration mode:
z
Select the closed user group.
x25 facility cug
group-number
or
x25 map
protocol address
[
protocol2
address2
[...[
protocol9 address9
]]]
x121-
address
cug
number
z
Set flow control parameter negotiation values to request on outgo-
ing calls.
x25 facility packetsize
in-size out-size
or
x25 map
protocol address
[
protocol2
address2
[...[
protocol9 address9
]]]
x121-
address
packetsize
in-size out-size
x25 facility windowsize
in-size out-size
or
x25 map
protocol address
[
protocol2
address2
[...[
protocol9 address9
]]]
x121-
address
windowsize
in-size outsize
z
Set reverse charging.
x25 facility reverse
or
x25 map
protocol address
[
protocol2
address2
[...[
protocol9 address9
]]]
x121-
address
reverse