Filter
Top Products
AI2524 Router Card User’s Manual
Page 16-4 August 1997
2524UM
6. To see the configuration in NVRAM, enter th
show startup-
config
command at the enable prompt:
Router# show startup-config
The results of the
show running-config
and
show star-
tup-config
commands will be different if you have mad
changes to the configuration but have not yet written them to
NVRAM.
7. To make your changes permanent, enter the
copy running-
config
startup-config command at the enable prompt:
Router# copy running-config startup-config
*******
The router is now configured and will boot with the configuration you
entered.
Using AutoInstall
The AutoInstall process is designed to configure the router automati-
cally after connection to your WAN. For AutoInstall to work properly,
a Transmission Control Protocol Internet Protocol (TCP/IP) host on
your network must be reconfigured to provide the required configura-
tion files. The TCP/IP host may exist anywhere on the network as long
as these conditions are maintained:
1. The host must be on the remote side of the router's synchronous
serial connection to the WAN.
2. User Datagram Protocol (UDP) broadcasts to and from the router
and the TCP/IP host must be enabled.
This functionality is coordinated by your system administrator at th
site where the TCP/IP host is located. You should not attempt to us
AutoInstall unless the required files have been provided on the TCP/
IP host.
AutoInstall works on synchronous serial connections only.
Take these steps to prepare your router for the AutoInstall process:
3. Attach the WAN cable to the router.