Filter
Top Products
AI2524 Router Card User’s Manual
Page 12-54 August 1997
2524UM
z
Display CMNS connections over LLC2.
show llc2
z
Display the protocol-to-X.121 address map.
show x25 map
z
Display routes assigned by the
x25 route
command.
show x25 route
z
Display details of active virtual circuits.
show x25 vc [lcn]
Example: Transparent Bridging for Multiprotocol LAPB
Encapsulation
This example configures transparent bridging for multiprotocol LAPB
encapsulation:
no ip routing
!
interface Ethernet 1
no ip address
no mop enabled
bridge-group 1
!
interface serial 0
no ip address
encapsulation lapb multi
bridge-group 1
!
bridge 1 protocol ieee
Example: X.25 Configured to Allow Ping Support over
Multiple Lines
For
ping
commands to work in an X.25 environment (when load
sharing over multiple serial lines), you must include entries for all ad-
jacent interface IP addresses in the
x25 map
command for each serial
interface. This example illustrates this point.
Consider two routers, Router A and Router B, communicating with
each other over two serial lines via an X.25 PDN (see Figure 12-8
) or
over leased lines. In either case, all serial lines must be configured fo
the same IP subnet address space. The configuration that follows al-