Filter
Top Products
Chapter 16: Basic Configuration
August 1997 Page 16-11
2524UM
3. Determine if you are going to enable IPX on the interface. If so,
enter yes and then enter the unique IPX network number:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B001
Configuring the
Synchronous
Serial Interfaces
The synchronous serial interfaces are configured to allow connection
to WANs. Once the Ethernet or Token Ring port on your router has
been configured, take these steps to configure the synchronous serial
interfaces:
1. Press <Enter> or enter yes to configure serial port 0:
Configuring interface SerialO:
Is this interface in use? [yes]:
2. Determine which protocols you want on the synchronous serial in-
terface and enter the appropriate responses. In this example, th
system is being configured for IP, AppleTalk, and IPX:
Configure IP on this interface? [yes:
Configure IP unnumbered on this interface? Loo]:
IP address for this interface: 172.16.73.1
Number of bits in sunned field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 4
AppleTalk ending cable range [3]: 4
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B002