Filter
Top Products
Chapter 5: Using AutoInstall
August 1997 Page 5-27
2524UM
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Router#
Use the Streamlined Setup Facility
The streamlined setup command facility is available only if you
router is running from ROM monitor and has RXBOOT ROMs in-
stalled. The streamlined setup command facility permits your router to
load a system image from a network server when there are problems
with the startup configuration. The Cisco IOS software automatically
puts you in the streamlined setup command facility when your router
is accidentally or intentionally rebooted (or you are attempting to load
a system image from a network server) after:
z
You issued an
erase startup-config
command, thereby
deleting the startup configuration file.
z
You have bit 6 (ignore NVRAM configuration) set in the config-
uration register.
z
Your startup configuration has been corrupted.
z
You configured the router to boot from a network server (the last
four bits of the configuration register are not equal to 0 or 1) and
there is no Flash or no valid image in Flash.
z
You configured the router to boot the RXBOOT image.
The streamlined setup command facility differs from the standard
setup command facility because the streamlined facility does not ask
you to configure global router parameters. You are prompted only to
configure interface parameters, which permit your router to boot.
This example shows a router entering the streamlined setup command
facility:
— System Configuration Dialog —
Default settings are in square brackets '[]'.
Configuring interface IP parameters for netbooting: