Filter
Top Products
AI2524 Router Card User’s Manual
Page 12-8 August 1997
2524UM
interface serial 2
ip address 172.25.9.1 255.255.255.0
!
encapsulation X25
!
The bandwidth command is not part of the X.25 configuration; it is es-
pecially important to understand that it does not have any connection
with the X.25 entity of the same name. bandwidth commands are used
by IP routing processes (currently only IGRP) to determine which
lines are the best choices for traffic. Since the default is 1544 Kbaud,
and X.25 service at that rate is not generally available, most X.25 in
terfaces that are being used with IGRP in a real environment will have
bandwidth settings.
This is a 9.6 Kbaud line:
bandwidth 10
These Level 3 parameters are default flow control values; they need to
match the PDN defaults. The values used by an SVC are negotiable on
a per-call basis:
x25 win 7
x25 wout 7
x25 ips 512
x25 ops 512
You must specify an X.121 address to be assigned to the X.25 inter-
face by the PDN.
x25 address 31370054065
These Level 3 parameters have been set to match the network. You
generally need to change some Level 3 parameters, most often those
listed below. You might not need to change any Level 2 parameters,
however.
x25 htc 32
x25 idle 5
x25 nvc 2