Filter
Top Products
AI2524 Router Card User’s Manual
Page 11-18 August 1997
2524UM
Figure11-1: Router Serial Interface Configured as a Half-
Bridge
Note: The Cisco IOS software supports no more than one PPP
half-bridge per Ethernet subnetwork.
Beginning in global configuration mode, configure a serial interface to
function as a half-bridge:
1. Specify the interface and enter interface configuration mode.
interface serial
number
2. Enable PPP half-bridging for one or more routed protocols:
ppp bridge ip
ppp bridge ipx [novell-ether | arpa | sap |
snap]
3. Provide a protocol address on the same subnetwork as the remote
network.
ip address
n.n.n.n
ipx network
network
Note: You must enter the ppp bridge command either when
the interface is shut down or before you provide a protocol
address for the interface.