Filter
Top Products
AI2524 Router Card User’s Manual
Page 5-18 August 1997
2524UM
Note: Verify that the existing and new routers and/or access
servers are connected before entering th copy
running-config startup-config EXEC
command to save configuration changes. Use the ping
EXEC command to verify connectivity. If an incorrect
configuration file is downloaded, the new router will load
NVRAM configuration information before it can enter
AutoInstall mode.
If the configuration file is a minimal configuration file, the new router
comes up, but with only one interface operational. Complete the fol-
lowing steps to connect to the new router and configure it:
1. Establish a Telnet connection to the existing router.
telnet
existing
2. From the existing router, establish a Telnet connection to the new
router.
telnet
newrouter
3. Enter privileged EXEC mode.
enable
password
4. Enter setup mode to configure the new router.
setup