Filter
Top Products
Chapter 14: T1 Interface Configuration Steps
August 1997 Page 14-5
2524UM
Specify Timeslots
To define timeslots for FT1/T1 module, type this in interface configu-
ration mode:
service-module t1 timeslots {
range
| all}
[speed {56 | 64}]
This command specifies which timeslots are used in fractional T1 op-
eration and determines the amount of bandwidth available to the route
in each timeslot.
The range specifies the DS0 timeslots that constitute the FT1/T1 chan-
nel. The range is from 1 to 24, where the first timeslot is numbered 1
and the last timeslot is numbered 24. Specify this field by using a series
of subranges separated by commas. The timeslot range must match the
timeslots assigned to the channel group. In most cases, the service pro-
vider defines the timeslots that comprise a channel group. Use th
no
form of this command to select all FT1/T1 timeslots transmitting at 64
kbps, which is the default.
To use the entire T1 line, enable the
service-module T1
timeslots all
command.