Filter
Top Products
AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 117
The VLAN Port Configuration Menu is shown in Figure 28 on page 114
4. Type V to select Set Port VID.
The following prompt is displayed:
Set PVID->Enter port number
5. Type the number of the port whose PVID value you want to configure
and press Enter. You can configure only one port at a time.
The following prompt is displayed:
Enter PVID for port
n
6. Type the new PVID for the port and press Enter. The PVID should
equal the VID of the VLAN where you want the port to be an untagged
member.
Note
If you specify a PVID that does not correspond to any VIDs on the
switch, the management software creates a new VLAN with a VID
that equals the PVID. The VLAN is not assigned any name.
7. Repeat steps 4 through 6 to configure additional ports.
Displaying the
VLANs
To display a list of the VLANs on the switch, perform the following
procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 28 on page 114.
The currently configured VLANs are displayed in a table with the
following columns of information:
VLAN ID
The ID of the VLAN.
VLAN Name
The name of the VLAN.
VLAN Type
The type of VLAN, either permanent or static. Only the Default VLAN is
permanent. All other and tagged VLANs are static.