Filter
Top Products
AT-S84 Management Software User’s Guide
Section II: Menus Interface 159
Configuring RSTP Port Settings
This section contains the following topics:
“Configuring the Basic RSTP Port Settings,” next
“Configuring the Advanced RSTP Port Settings” on page 161
Configuring the
Basic RSTP Port
Settings
To configure the basic RSTP port settings, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type S to select Rapid
Spanning Tree Configuration.
The Rapid Spanning Tree Configuration Menu is shown in Figure 42
on page 153.
3. From the Rapid Spanning Tree Configuration Menu, type B to select
RSTP Basic Port Configuration.
The RSTP Basic Port Configuration menu is shown in Figure 43.
Figure 43. RSTP Basic Port Configuration Menu
AT-9000/24 Local Management System
Rapid Spanning Tree Configuration -> RSTP Basic Port Configuration
Port Trunk Link State Role Priority Path Cost STP Status
---- ----- ---- ---------- --------- -------- --------- ----------
1 --- Up Forwarding Disabled 128 200000 Disabled
2 --- Down Forwarding Disabled 128 200000 Enabled
3 --- Up Forwarding Root 128 200000 Enabled
4 --- Down Forwarding Disabled 128 200000 Enabled
5 --- Down Forwarding Disabled 128 200000 Enabled
6 --- Down Forwarding Disabled 128 200000 Enabled
7 --- Down Forwarding Disabled 128 200000 Enabled
8 --- Down Forwarding Disabled 128 200000 Enabled
9 --- Down Forwarding Disabled 128 20000 Enabled
10 --- Down Forwarding Disabled 128 20000 Enabled
11 --- Down Forwarding Disabled 128 20000 Enabled
12 --- Down Forwarding Disabled 128 20000 Enabled
----------------------------- <COMMAND> ---------------------------------
Set Port Pr[i]ority Set Port STP [S]tatus
Set Path [C]ost [Q]uit to previous menu
Command>