Filter
Top Products
Chapter 20: Port Trunking
244 Section II: Web Browser Interface
The LACP Group Status page displays the following information about
the LACP group:
System Priority
The system priority as defined by IEE 802.3ad. You cannot change
this.
System ID
The MAC address of the system.
Key
The key for this trunk group.
The page also contains a table that displays the following information:
Aggregator
The port that is operating as the aggregator.
Attached Port List
The ports assigned to the aggregator.
Disabling an
LACP Trunk
To create an LACP trunk, perform the following procedure:
1. From the Advanced Config menu, select Trunk Config.
The Trunk Configuration page is shown in Figure 71 on page 240.
2. From the list at the end of the port list for the trunk you want to disable,
choose Passive.
3. Click Apply.