Filter
Top Products
Chapter 17: Basic Switch Parameters
224 Section II: Web Browser Interface
Returning the AT-S84 Management Software to the Factory Default
Values
This procedure returns all AT-S84 management software parameters to
their default values and deletes all tagged and VLANs on the switch. The
AT-S84 management software default values are listed in Appendix A,
“AT-S84 Default Settings” on page 311.
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
To return the AT-S84 management software to the default settings,
perform the following procedure:
1. From the Tools menu, select System Reboot.
The System Reboot Configuration page is shown in Figure 63 on page
219.
2. For the Reboot Type, select one of the following:
Reset to Factory Default
Resets all switch parameters to the factory default settings, including
IP address, subnet mask, and gateway address.
Reset to Factory Default Except IP Address
Resets all switch parameters to the factory default settings, but retains
the IP address, subnet mask, and gateway settings. If the DHCP client
is enabled, it remains enabled after this reset.
3. For the Reboot Status, select Start to start the reboot.
4. Click Apply.
The switch is rebooted. You must wait for the switch to complete the
reboot process before reestablishing your management session.