Filter
Top Products
Chapter 3: Basic Switch Parameters
42 Section I: Using the Menus Interface
Disabling or Enabling the Web Server
The AT-S84 management software is shipped with web server software.
The software is available so that you can remotely manage the switch with
a web browser from any management station on your network. (The
instructions for managing a switch with a web browser are described in
Chapter 16, “Starting a Web Browser Management Session” on page
199.)
The default setting for the web server is enabled,
To disable or enable the web server, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration Menu, type U to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
38.
3. From the User Interface Configuration Menu, type W to select Enable/
Disable Web Server.
The following prompt is displayed:
Enable or Disable Web server (E/D)>
4. Type D to disable the web server or E to enable it.