Filter
Top Products
Chapter 23: Quality of Service (QoS)
262 Section II: Web Browser Interface
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues, as shown in Table 2 on page 127. This
is set at the switch level. You cannot set this at the per-port level. This
procedure also enables and disables QoS.
To change the default mappings of CoS priorities to egress priority queues
or to enable or disable QoS, perform the following procedure:
1. From the Advanced Config menu, select QoS Config > Traffic
Class.
The Traffic Class Configuration page opens, as shown in Figure 80.
Figure 80. Traffic Class Configuration Page
2. To enable or disable QoS, select Enable or Disable from the QoS
Status list. The default is disabled.
3. To change the egress priority queue assignment of an 802.1p priority
class, click the dialog circle of the queue for the corresponding priority.
For example, to direct all tagged traffic with a priority of 4 to egress
queue 3 on the ports, you would click the button for queue 3 in the
priority 4 row.
4. Click Apply.