Filter
Top Products
AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 123
GVRP is only aware of those VLANs that have active nodes, or where
at least one end node of a VLAN has established a valid link with a
switch. GVRP is not aware of a VLAN if there are no active end nodes
or if no end nodes have established a link with the switch.
Enabling or
Disabling GVRP
GVRP is disabled by default.
To enable or disable GVRP, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 28 on page 114.
3. From the The VLAN Management Menu, type G to select Set GVRP
Status.
The following prompt is displayed:
Enable or Disable GVRP status (E/D)>
4. Type E to enable GVRP or D to disable it.