Filter
Top Products
Chapter 12: 802.1x Network Access Control
176 Section I: Using the Menus Interface
F (Force-authorized) - Disables IEEE 802.1x authentication and
causes the port to transition to the authorized state without any
authentication exchange required. The port transmits and receives
normal traffic without 802.1x-based authentication of the client.
This is the default setting.
b. Type A, U, or F.
8. To configure the transmission period, do the following:
a. Type T to select Transmission Period.
The following prompt is displayed:
Enter transmission period >
This parameter sets the number of seconds that the switch waits
for a response to an EAP-request/identity frame from the client
before retransmitting the request. The default value is 30 seconds.
The range is 1 to 65,535 seconds.
b. Type a number for the transmission period.
9. To set the supplicant timeout, do the following:
a. Type L to select Supplicant Timeout.
The following prompt is displayed:
Enter supplicant timeout value >
This parameter sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this parameter is 30
seconds. The range is 1 to 600 seconds.
b. Type a number for the supplicant timeout.
10. To set the server timeout, do the following:
a. Type O to select Server Timeout.
The following prompt is displayed:
Enter transmission period >
This parameter sets the timer used by the switch to determine
authentication server timeout conditions. The default value for this
parameter is 10 seconds. The range is 1 to 60 seconds.
b. Type a number for the server timeout.
11. To set the maximum number of requests, do the following:
a. Type M to select Maximum Request.