Filter
Top Products
Chapter 3: Basic Switch Parameters
36 Section I: Using the Menus Interface
Configuring System Administration Information
This section explains how to assign a name to the switch, as well as
specify the location of the switch and the name of the switch’s
administrator. Entering this information is optional.
To set a switch’s administration information, perform the following
procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration Menu, type A to select System
Administration Information.
The System Administration Configuration Menu is shown in Figure 6.
Figure 6. System Admin. Configuration Menu
The Description parameter in the top portion of the menu displays the
model name of the switch. The System Object ID parameter is the
numeric ID of the switch. You cannot change these parameters.
3. To set the system’s name, do the following:
a. Type N to select Set System Name.
The following prompt is displayed:
AT-9000/24 Local Management System
Basic Switch Configuration -> System Admin. Configuration Menu
Description: AT-9000/24
ObjectID: 1.3.6.1.4.1.207.1.4
Name:
Location:
Contact:
----------------------- <COMMAND> -----------------------------
Set System [N]ame
Set System [L]ocation
Set System [C]ontact Information
[Q]uit to previous menu
Command>