Filter
Top Products
Chapter 29: Working with System Files
290 Section II: Web Browser Interface
Downloading a New Management Software Image Using TFTP
Before downloading a new version of the AT-S84 management software
onto the switch, note the following:
The current configuration of a switch is retained when a new AT-S84
software image is installed. To return a switch to its default
configuration values, refer to “Returning the AT-S84 Management
Software to the Factory Default Values” on page 57.
Your network must have a node with TFTP server software.
You must store the new AT-S84 image file on the server.
You should start the TFTP server software before you begin the
procedure.
The switch where you are downloading the image file must have an IP
address and subnet mask. For instructions on how to configure the IP
address on a switch, refer to “Configuring the IP Address, Subnet
Mask, and Gateway Address” on page 32 or “Enabling and Disabling
the DHCP Client” on page 35.
Caution
Downloading a new version of management software onto the
switch causes the device to reset. Some network traffic may be lost
during the reset process.
This procedure assumes that you have already obtained the software and
have stored it on the computer from which you will be performing this
procedure.
To download the AT-S84 image software onto the switch, perform the
following procedure:
1. From the Tools menu, select Image Upgrade.
The Image Upgrade page opens, as shown in Figure 91.
Figure 91. Image Upgrade Page