Filter
Top Products
Procedures 12-59
Octel 200/300 S.4.1
PB60019−01
The Octel 200/300 displays the following screen. (There may be a delay
before the screen appears.)
:B4
Selected drive has been replaced.
To reload the system.
To display the boot process.
Refer to
Installation, Octel 200/300 Testing section, in this volume.
To list the Hardware Error Table.
If errors appear, refer to the System Errors And Traffic Peg chapter.
14. Enter the number of the drive
slot to be replaced.
Reload the System
15. Make sure the configuration
backup disk is write-enabled.
16. Insert the configuration backup
disk into the floppy drive.
17. Press the lower button
on the CPU.
18. Press
Enter
19. Log on to the system using the
maintenance password.
20. Verify correct system operation.
21. @L H