Filter
Top Products
7-50
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Enabling the Second Processor on the NPE-G1
CPU% per hour (last 72 hours)
* = maximum CPU% # = average CPU%
Using the show mpf interface Command
Using the show mpf interface command without arguments shows the interface information for all
Gigabit Ethernet interfaces and subinterfaces. This command is supported only for physical interfaces.
There is no support for the virtual access interface.
Router# show mpf interface
Name Index State Counter Count
Gi0/1 0 up RX packets 1004
RX bytes 158632
TX packets 5004
TX bytes 790632
RX punts 32961
TX punts 85972
Gi0/1 1 up
Gi0/1.100 100 up RX packets 1004
RX bytes 158632
TX packets 5004
TX bytes 790632
RX punts 25
Gi0/1.101 101 up
Gi0/1.102 102 up
Gi0/1.105 105 up
Gi0/1.106 106 up
Gi0/1.107 107 up
Gi0/1.200 200 up
Gi0/1.201 201 up RX punts 29
Gi0/1.202 202 up
Gi0/1.206 206 up
Gi0/1.2002 602 up RX punts 26114
Gi0/1.2004 604 up
Using the show mpf interface GigabitEthernet 0/1 Command
The following example displays the interface information for GigabitEthernet 1/0, subinterface number
100. However, all Gigabit Ethernet interface and subinterface information is displayed because MPF
does not recognize the subinterface number, unless it is a VLAN number.
Router# show mpf interface GigabitEthernet 0/1.100
Name Index State Counter Count
Gi0/1 0 up RX packets 1004
RX bytes 158632
TX packets 5004
TX bytes 790632
RX punts 32996
TX punts 86062
Gi0/1 1 up
Gi0/1.100 100 up RX packets 1004
RX bytes 158632
TX packets 5004
TX bytes 790632
RX punts 25
Gi0/1.101 101 up
Gi0/1.102 102 up
Gi0/1.105 105 up
Gi0/1.106 106 up
Gi0/1.107 107 up
Gi0/1.200 200 up