Filter
Top Products
5-10
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 5 NPE-G1 Overview
Connection Equipment and Specifications
Connection Equipment and Specifications
This section contains connection equipment and pinout information for the Gigabit Ethernet RJ-45 ports,
Gigabit Interface Converter (GBIC) ports, console port, and auxiliary port that are located on the
NPE-G1.
Ethernet and Fast Ethernet RJ-45 Connection Equipment
The NPE-G1 has RJ-45 ports for Ethernet, Fast Ethernet, and Gigabit Ethernet or autosensing Ethernet,
Fast
Ethernet, and Gigabit Ethernet connections. The RJ-45 port supports IEEE 802.3 (Ethernet) and
IEEE
802.3u (Fast Ethernet) interfaces compliant with 10BASET, 100BASETX, and 1000BASET and
1000BASEX specifications.
The RJ-45 ports support standard straight-through and crossover Category 5 UTP cables with RJ-45
connectors. (See
Figure 5-5) Cisco does not supply Category 5 UTP cables; these cables are available
commercially.
NVRAM 512 KB 1 Nonvolatile EPROM for the system
configuration file
U7
Primary cache 32 KB (16 KB instruction,
16
KB data)
— BCM1250 system, internal cache U22
Secondary cache 512 KB — BCM1250 system, internal, unified cache U22
1. The NPE-G1 requires that locations J3 and J4 always contain two SODIMMs of the same size.
Ta ble 5-2 NPE-G1 SDRAM SODIMM Configurations—Configurable Memory Only
Total SDRAM SDRAM Bank Quantity Product Number
256 MB J3 and J4 2 128-MB SODIMMs MEM-NPE-G1-256MB=
512 MB J3 and J4 2 256-MB SODIMMs MEM-NPE-G1-512MB=
1 GB J3 and J4 2 512-MB SODIMMs MEM-NPE-G1-1GB=
Ta ble 5-3 NPE-G1 CompactFlash Disk Specifications
Memory Size Product Number
64 MB MEM-NPE-G1-FLD64=
128 MB MEM-NPE-G1-FLD128=
256 MB MEM-NPE-G1-FLD256=
Table 5-1 NPE-G1 Memory Specifications (continued)
Memory Type Size Quantity Description
Component
Location on the
NPE-G1 Board