Filter
Top Products
10-6
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 10 Configuration Tasks and Troubleshooting Information
NSE-1 show Commands
0x20:37 35 20 20 20 04 00 02 02 85 1C 0C 4A 02 CB 84
0x30:4E 53 45 31 FF FF FF FF FF FF FF FF FF FF FF FF
0x40:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x50:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70:FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Using the show environment Command with the NPE-G2—NPE-G2 -Specific Output
The output for the show environment command has changed slightly for the NPE-G2. See the NPE-G2
Support for the show environment Command document for information about changes to the output of
the show environment command with the NPE-G2 at:
http://www.cisco.com/en/US/docs/ios/12_4/12_4x/12_4_4xd/showenv2.html.
NSE-1 show Commands
Following are five NSE-1-specific show pxf commands and several subcommands. Included in this
section are examples for each command.
• show pxf accounting ?
–
show pxf accounting summary
–
show pxf accounting interface
• show pxf crash
• show pxf info
• show pxf interface
• show pxf feature ?
Sample output for these commands and subcommands follows.
Using the show pxf accounting ? Command and Subcommands
The following is an example of the show pxf accounting ? command with sample output:
Router# show pxf accounting ?
ATM ATM interface
Ethernet IEEE 802.3
FastEthernet FastEthernet IEEE 802.3
Hssi High Speed Serial Interface
Null Null interface
POS Packet over Sonet
Serial Serial
summary PXF summary statistics
The following is an example of the show pxf accounting summary command with sample output:
Router# show pxf accounting summary
Pkts Dropped RP Processed Ignored
Total 0 90 0
PXF complex busy : 8%
PXF input pipeline full: 0%