Filter
Top Products
9-4
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 9 Removing and Installing the NPE or NSE
Removing and Replacing the NPE or NSE
Disconnecting AC-Input Power from a Cisco 7200 Series Router or Cisco 7200 VXR Router
To disconnect AC-input power from a Cisco 7200 series router or Cisco 7200 VXR router, complete the
following steps:
Step 1 Unplug the input power cable from the power source.
Step 2 Push up on the cable-retention clip that secures the input power cable to the router power supply.
Step 3 Unplug the other end of the input power cable from the power supply. See Figure 9-1.
Figure 9-1 Disconnecting Power from a Cisco 7200 Series AC-Input Power Supply
Step 4 Repeat Step 1 through Step 3 if a second power supply is installed.
This completes the procedure for disconnecting AC-input power from a Cisco 7200 series router or
Cisco 7200 VXR router. Go to the
“Removing the NPE or NSE” section on page 9-9.
Disconnecting AC-Input Power from a Cisco uBR7200 Series Router
To disconnect AC-input power from a Cisco uBR7200 series router, complete the following steps:
Step 1 Unplug the input power cable from the power source.
Step 2 Push the cable-retention clip that secures the input power cable to the router power supply to the left.
Step 3 Unplug the other end of the input power cable from the power supply. See Figure 9-2.
1 AC-input receptacle 3 Power switch
2 Internal fans 4 AC-input power supply
NETW
ORK PROCESSING ENGINE-300
66415
3
2
4
1