Compaq AA-RHGWC-TE Server User Manual


 
5.7 Upgrading Memory Channel Adapters
If you have a TruCluster Server configuration with redundant MC1
interconnects and want to upgrade to MC2 interconnects, you can do so
without shutting down the entire cluster.
When rolling from MC1 interconnects, which use 128 MB Memory Channel
address space, to MC2, which uses either 128 or 512 MB Memory Channel
address space, all Memory Channel adapters must be operating at 128 MB
Memory Channel address space (the default) until the last adapter has been
changed. At that time the address space can be increased to 512 MB if all
MC2 adapters are jumpered for 512 MB.
This section covers adding a Memory Channel interconnect and the following
rolling upgrade situations:
Dual, redundant MC1 interconnects in virtual hub mode (Table 54
and Figure 52)
Dual, redundant MC1 interconnects in standard hub mode (Table 54
and Figure 53 through Figure 58)
The figures following Table 54 provide two sequences that you can follow
while carrying out the steps of Table 54. Figure 52 shows a dual,
redundant virtual hub configuration using MC1 hardware being upgraded
to MC2. Figure 53 through Figure 58 show a three-node standard hub
configuration being upgraded from MC1 to MC2.
______________________ Note _______________________
When you upgrade from dual, redundant MC1 hardware to
dual, redundant MC2 hardware, you must replace all the MC1
hardware on one interconnect before you start on the second
interconnect (except as described in step 4 of Table 54).
Memory Channel adapters jumpered for 512 MB may require a
minimum of 512 MB physical RAM memory. Ensure that your
system has enough physical memory to support the upgrade. For
two MC2 Memory Channel adapters, you will need more than 1
GB of physical memory.
514 Setting Up the Memory Channel Cluster Interconnect