– The lower bay bottom shelf tape drive (tape drive 0, SCSI ID 3) is on
SCSI Port C and is terminated on the tape drive.
– The tape drive terminators are 68-pin differential terminators (part
number 0415619).
Figure 8–16: TL896 Six-Bus Configuration
MUC
SCSI Address 2
SCSI Port D
SCSI Port E
SCSI Port F
TZ89 Drive 5
SCSI Address 5
(top shelf)
TZ89 Drive 4
SCSI Address 4
(middle shelf)
TZ89 Drive 3
SCSI Address 3
(bottom shelf)
0425031 (SCSI Diff Feed Through)
ZK-1327U-AI
(Rear Connector Panel)
0415498 (50-Pin Micro-D Terminator)
0425017 (Cable)
6204099-01
6204099-01
6204099-01
TZ89 Drive 2
SCSI Address 5
(top shelf)
TZ89 Drive 1
SCSI Address 4
(middle shelf)
TZ89 Drive 0
SCSI Address 3
(bottom shelf)
6204099-01
6204099-01
6204099-01
SCSI Port A
SCSI Port B
SCSI Port C
SCSI Port G
SCSI Port H
SCSI Port I
Upper
Bay
Lower
Bay
0415619
(68-pin Terminator)
0415619
(68-pin Terminator)
0415619
(68-pin Terminator)
0415619
(68-pin Terminator)
0415619
(68-pin Terminator)
8.11.6 Connecting the TL893 and TL896 Automated Tape Libraries to
the Shared SCSI Bus
The TL893 and TL896 Automated Tape Libraries (ATLs) have up to 3
meters of internal SCSI cabling on each SCSI bus. Because of the internal
SCSI cable lengths, it is not possible to use a trilink connector or Y cable to
terminate the SCSI bus external to the library as is done with other devices
8–54 Configuring a Shared SCSI Bus for Tape Drive Use