Compaq AA-RHGWC-TE Server User Manual


 
The maximum number of drives behind an HSG80 (single or
dual-redundant pair) using three dual-bus Model 4254 disk
enclosures is 42.
The Model 4214R and Model 4254 disk enclosures support
only the new Compaq hot-pluggable wide-UltraSCSI low
voltage differential (LVD) disk drives.
For more information on configuring the MA8000/EMA12000, see the
Compaq StorageWorks Modular Array Configuration Guide.
Only disk devices attached to the HSG60 or HSG80 Fibre Channel array
controller are supported with the TruCluster Server product.
No tape devices are supported behind an HSG60 or HSG80 RAID array
controller.
The only supported Fibre Channel adapters are the KGPSA-BC and
KGPSA-CA PCI-to-Fibre Channel host bus adapters.
The KGPSA-BC/CA PCI-to-Fibre Channel adapters are only supported
on the DWLPB PCIA option; they are not supported on the DWLPA.
A host is only allowed to have one KGPSA connected to each switch
or switch zone.
The only Fibre Channel switches supported are the DS-DSGGA-AA/AB
8/16 port, DS-DSGGB-AA/AB 8/16 port, or DS-DSGGC-AA 8 port Fibre
Channel switches.
The DSGGA and DSGGB Fibre Channel switches support both
shortwave (GBIC-SW) and longwave (GBIC-LW) GigaBit Interface
Converter (GBIC) modules. Seven of the eight DSGGC ports are fixed
shortwave optical transceivers. Only one DSGGC port is configured as a
removable GBIC. It may be shortwave or longwave.
The GBIC-SW module supports 50-micron, multimode fiber cables with
the standard subscriber connector (SC) connector in lengths up to 500
meters. The GBIC-LW supports 9-micron, single-mode fiber cables with
the SC connector in lengths up to 10 kilometers.
The KGPSA-BC/CA PCI-to-Fibre Channel host bus adapters and the
HSG60 and HSG80 RAID controller support the 50-micron Gigabit Link
Module (GLM) for fiber connections. Therefore, only the 50-micron
multimode fiber optical cable is supported between the KGPSA and
switch and the switch and HSG60 or HSG80 for cluster configurations.
You must install GBIC-SW GBICs in the DSGGA and DSGGB Fibre
Channel switches (or one DSGGC open port) for communication between
the switches and KGPSA or HSG60/HSG80.
Hardware Requirements and Restrictions 27