Filter
Top Products
6.2.2.2
Fabric .........................................................
6–7
6.2.2.3
Arbitrated Loop Topology ..................................
6–8
6.3
Example Fibre Channel Configurations Supported by
TruCluster Server .....................................................
6–9
6.3.1
Fibre Channel Cluster Configurations for Transparent
Failover Mode .....................................................
6–10
6.3.2
Fibre Channel Cluster Configurations for Multiple-Bus
Failover Mode .....................................................
6–11
6.4
Zoning and Cascaded Switches ..................................... 6–14
6.4.1
Zoning ..............................................................
6–14
6.4.2
Cascaded Switches ...............................................
6–15
6.5
Installing and Configuring Fibre Channel Hardware ........... 6–16
6.5.1
Installing and Setting Up the Fibre Channel Switch ...... 6–16
6.5.1.1
Installing the Switch ........................................ 6–17
6.5.1.2
Managing the Fibre Channel Switches .................. 6–18
6.5.1.2.1
Using the Switch Front Panel ........................ 6–19
6.5.1.2.2
Setting the Ethernet IP Address and Subnet Mask
from the Front Panel ................................... 6–19
6.5.1.2.3
Setting the DS-DSGGB-AA and DS-DSGGC-AA
Ethernet IP Address and Subnet Mask from a PC
or Terminal ..............................................
6–21
6.5.1.2.4
Logging In to the Switch with a Telnet Connection 6–22
6.5.1.2.5
Setting the Switch Name via Telnet Session ....... 6–23
6.5.2
Installing and Configuring the KGPSA PCI-to-Fibre
Channel Adapter Module ....................................... 6–23
6.5.2.1
Installing the KGPSA PCI-to-Fibre Channel Adapter
Module ........................................................ 6–23
6.5.2.2
Setting the KGPSA-BC or KGPSA-CA to Run on a
Fabric ......................................................... 6–24
6.5.2.3
Obtaining the Worldwide Names of KGPSA Adapters 6–27
6.5.3
Setting Up the HSG80 Array Controller for Tru64 UNIX
Installation ........................................................ 6–28
6.5.3.1
Obtaining the Worldwide Names of HSG80 Controller 6–33
6.6
Installing Tru64 UNIX and TruCluster Server Software Using
Fibre Channel Storage ............................................... 6–34
6.6.1
Before You Install ................................................ 6–36
6.6.1.1
Configure the HSG80 Storagesets ........................ 6–36
6.6.1.2
Adding Units and Identifiers to the HSG80
Storagesets ................................................... 6–40
6.6.1.3
Set the Device Unit Number ............................... 6–43
6.6.1.4
Displaying the Available Boot Devices ................... 6–48
6.6.1.5
Set the bootdef_dev Console Environment Variable for
Tru64 UNIX Installation ................................... 6–49
vi Contents