Filter
Top Products
8.1.1 Setting the TZ88N-VA SCSI ID
You must set the TZ88N-VA switches before the tape drive is installed into
the BA350 StorageWorks enclosure. The Automatic selection is normally
used. The TZ88N-VA takes up three backplane slot positions. The physical
connection is in the lower of the three slots. For example, if the tape drive is
installed in slots 1, 2, and 3 with the switches in Automatic, the SCSI ID
is 3. If the tape drive is installed in slots 3, 4, and 5 with the switches in
Automatic, the SCSI ID is 5. The switch settings are shown in Table 8–1.
Figure 8–1 shows the TZ88N-VA with the backplane interface connector and
SCSI ID switch pack.
Figure 8–1: TZ88N-VA SCSI ID Switches
Snap−in
Locking
Handles
SCSI ID
Switch Pack
Backplane
Interface
Connector
TZ88N−VA
8–2 Configuring a Shared SCSI Bus for Tape Drive Use