HSG80 controller,6–34
requirements
SCSI bus
,3–1, 9–1
reset,6–25, 6–48
resetting offsets
,6–59
restrictions,2–8
disk devices,2–9
KZPBA-CB adapters,2–9
KZPSA adapters,2–8
Memory Channel interconnects
,
2–3
SCSI bus adapters,2–5
rolling upgrade
MC1 to MC2
,5–14
S
SAVE_CONFIGURATION
command
,6–34
SC connector
( See subscriber connector )
SCM,7–4
master,7–5
master-designate,7–5
powered by,7–4
purpose,7–4
slave,7–5
SCM command
power on
,7–12
set hp_count,7–10
set hp_qbb_mask,7–10
show nvr,7–10
scm_csb_master_eligible,7–5, 7–12
SCSI
number of devices supported
,3–2
SCSI bus with BA350 and BA356,
9–18
SCSI bus with Two BA356s,9–20
SCSI bus with two UltraSCSI BA356s,
9–22
SCSI buses
( See shared SCSI buses )
SCSI cables
( See cables )
requirement,2–13
SCSI controllers
bus speed for
,3–5
SCSI ID selection
,9–17
BA356,9–16
SCSI IDs
BA350
,9–9
BA350 storage shelves
,9–15
BA356,9–11, 9–16
HSZ20 controller,9–24
HSZ40 controller,9–24
HSZ50 controller,9–24
in BA356,9–11
in UltraSCSI BA356,9–13
RAID subsystem controllers,9–24
requirement,3–5
UltraSCSI BA356
,9–13, 9–17
SCSI targets
number of
,2–8
SCSI terminators
supported
,2–14
SCSI-2 bus
,3–5
selecting BA356 disk SCSI IDs
,9–11
selecting UltraSCSI BA356 disk SCSI
IDs
,9–13
set bootdef_dev,6–50, 6–56, 6–57
set hp_count,7–10
set hp_qbb_maskn,7–10
set scm_csb_master_eligible
,7–12
setting bus speed
KZPSA
,10–17
setting SCSI ID
20/40 GB DLT Tape Drive
,8–10
40/80-GB DLT Drive,8–14
Compaq 20/40 GB DLT Tape Drive,
8–10
Compaq 40/80-GB DLT Drive,8–14
DS-TZ89N-TA,8–9
DS-TZ89N-VW,8–6
KZPSA,10–17
Index–9