Compaq AA-RHGWC-TE Server User Manual


 
4.3.3.2 Setting the KZPBA-CB SCSI ID
After you determine the console environment variables for the KZPBA-CBs
on the shared SCSI bus, use the set console command to set the SCSI
ID. For a TruCluster Server cluster, you will most likely have to set the
SCSI ID for all KZPBA-CB UltraSCSI adapters except one. And, if you are
using a DS-DWZZH-05, you will have to set the SCSI IDs for all KZPBA-CB
UltraSCSI adapters.
______________________ Notes ______________________
You will have problems if you have two or more SCSI adapters at
the same SCSI ID on any one SCSI bus.
If you are using a DS-DWZZH-05, you cannot use SCSI ID 7
for a KZPBA-CB UltraSCSI adapter; SCSI ID 7 is reserved for
DS-DWZZH-05 use.
If DS-DWZZH-05 fair arbitration is enabled, The SCSI ID of the
host adapter must match the SCSI ID assigned to the hub port.
Mismatching or duplicating SCSI IDs will cause the hub to hang.
SCSI ID 7 is reserved for the DS-DWZZH-05 whether fair arbitration is
enabled or not.
Use the set console command as shown in Example 47 to set the SCSI ID.
In this example, the SCSI ID is set for KZPBA-CB pkc on the AlphaServer
DS20 shown in Example 45.
Example 47: Setting the KZPBA-CB SCSI Bus ID
P00>>> show pkc0_host_id
7
P00>>> set pkc0_host_id 6
P00>>> show pkc0_host_id
6
4.3.3.3 KZPBA-CB Termination Resistors
The KZPBA-CB internal termination is disabled by removing the
termination resistors RM1-RM8, as shown in Figure 41.
TruCluster Server System Configuration Using UltraSCSI Hardware 417