Dell 3348 Switch User Manual


 
200 Configuring Switch Information
www.dell.com | support.dell.com
Assigning IP-based ACEs to ACLs Using the CLI Commands
The following table summarizes the equivalent CLI commands for assigning IP-based
ACEs to ACLs as displayed in the Add ACE to IP Based ACL page.
The following is an example of the CLI commands:
Permit 00:00:bo:11:11:11 0:0:0:0:0:0 any VLAN 4
deny 00:00:bo:11:11:11 0:0:0:0:0:0 any VLAN 4
Defining MAC-Based ACLs
The Add ACE to MAC Based ACL page allows network administrators to define MAC-
based Access Control Entry (ACE) and Access Control Lists (ACLs). ACEs act as filters to
match packets to forwarding criteria. To open the Add ACE to MAC Based ACL:
Select Switch > Network Security > MAC Based ACL. The Add ACE to MAC
Based ACL page opens.
CLI Command Description
ip access-list name Enters to IP-Access list
configuration mode.
permit {any | protocol} {any |
{source source-wildcard}} {any
| {destination destination-
wildcard}} [dscp dscp number | ip-
precedence ip-precedence]
Allows traffic if the conditions
defined in the permit statement
are matched.
deny [disable-port] {any| protocol}
{any | {source source-
wildcard}} {any | {destination
destination-wildcard}} [dscp
dscp number | ip-precedence ip-
precedence]
Denies traffic if the conditions
defined in the deny statement are
matched.