Configuring the PowerConnect 3324/3348 Switch 47
BOOT Software Version 1.30.11 Built 27-JAN-2003 10:06:03
Processor: MPC8245 Rev 0.12, 250 MHz (Bus: 100MHz), 32 MByte SDRAM.
I-Cache 16 KB, linesize 32.D-Cache 16 KB, linesize 32.
Cache Enabled.
Autoboot in 2 seconds - press RETURN or Esc. to abort and enter
prom.
The auto-boot message that appears at the end of the POST (see the last lines) indicates
that no problems were encountered during boot.
At this point, a user input can be entered to get the Startup menu if it is necessary to run
special procedures that can be invoked from this menu. To enter the Startup menu, the
<Esc> or <Enter> keys must be pressed within the first two seconds after the auto-boot
message appears. For details regarding the Startup menu, see Startup Menu Functions.
If no user input is entered, the system continues operation by decompressing the code into
RAM. The code starts running from RAM and the list of available port numbers and their
states (up or down) are displayed.
NOTE: The following screen is an example configuration. Items such as addresses, versions, and
dates may differ for each device.
Preparing to decompress.
Decompressing SW from RSCOD_2
85e000
OK
Running from RAM.
******************************************************Running SW
Ver. 3.30 Date 03-Feb-2003 Time 10:10:37
******************************************************
HW version is X.X
Base Mac address is: 00:01:02:03:04:05
Dram size is: 32M bytes
Dram first block size is: 20M bytes
Dram first PTR is: 0xB70000
Flash size is: 8M