Filter
Top Products
278 Configuring Switch Information
www.dell.com | support.dell.com
Configuring LACP Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring LACP
parameters as displayed in the Link Aggregation page.
The following is an example of the CLI commands:
Console (config)# lacp system-priority 120
Console (config)# interface ethernet 1/e8
Console (config-if)# lacp port-priority 247
Console (config-if)# lacp timeout long
Console (config-if)# exit
Console# show lacp ethernet 1/e1 statistics
Port 1/e1 LACP Statistics:
LACP PDUs sent:2
LACP PDUs received:2
CLI Command Description
lacp system-priority value Configures the system priority.
lacp port-priority value Configures the priority value for physical
ports.
lacp timeout {long | short} Assigns an administrative LACP
timeout.
show lacp ethernet
interface [parameters |
statistics | protocol-state]
Displays LACP information for ethernet
ports.
show lacp port-channel
[port_channel_number]
Displays LACP information for a Port-
channel.