Dell 3348 Switch User Manual


 
76 Configuring the PowerConnect 3324/3348 Switch
www.dell.com | support.dell.com
4 Select Unit 2 using the Stack ID button within 15 seconds.
5 Repeat steps 3 and 4 for all stacking members.
NOTE: Stack the units according to their Unit ID. For example, the Master Unit is stacked
first, with Unit 2 directly below the Master Unit.
Expanding the Stack
This section contains instructions for adding stacking members. To expand a stack:
NOTE: The Stack Unit ID must be selected within 15 seconds.
1
Ensure that the stack is operating correctly.
2 Connect the lower Stacking connector to the additional stacking Member unit.
3 Plug in new stacking unit. The device begins to boot.
4 Select the unit number using the Stack ID button within 15 seconds.
5 For each new member, open the existing ring and connect the new member’s Stacking
cable.
For information on replacing stacking members and reassigning Unit IDs, see "Replacing
Stack Members".
Rebooting the Device
NOTE: Before rebooting the device, save the device configuration. After the device is reset, all
unsaved configuration changes are lost.
1
Enter the CLI mode. The following prompt displays:
Console > enable
2
Enter Reload. The following message displays:
>reload
This command will restart the whole system and disconnect your
current session. Do you want to continue?
3
Enter Y. The device reboots.