Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
98
Syntax
sho
w bandwidth control [<portlist> | all]
Description The show bandwidth_control command displays bandwidth
control.
Parameters portlis t– A port or range of ports to be configured.
all – Specifies that the show bandwidth_control command applies
to all ports on the Switch.
Restrictions None.
Example usage:
T o display the bandwidth control configuration:
DGS3100# show bandwidth_control all
Bandwidth Control Table
Port RX Rate TX Rate
–––– ––––––––––––– –––––––––––––
1 no_limit no_limit
2 no_limit no_limit
3 no_limit no_limit
4 no_limit no_limit
5 no_limit no_limit
6 no_limit no_limit
7 no_limit no_limit
8 no_limit no_limit
9 no_limit no_limit
10 no_limit no_limit
11 no_limit no_limit
12 no_limit no_limit
13 no_limit no_limit
14 no_limit no_limit
15 no_limit no_limit
16 no_limit no_limit
17 no_limit no_limit
Total entries : 17
DGS3100#
config 802.1p user_priority
Purpose To map the 802.1p user priority of an incoming packet to one of the
four hardware classes of service available on the Switch.
Syntax
config 802.1p user_priority <priority 0-7> <class_id 0-3>
Description The config 802.1p user_priority command configures the way the
Switch maps an incoming packet, based on its 802.1p user priority
tag, to one of the four hardware priority classes of service available
on the Switch. The Switch’s default is to map the incoming 802.1p
priority values to the four hardware classes of service according to
the following chart: