Filter
Top Products
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
17
rate and a
uto logout settings.
Parameters baud rate [2400 | 4800 | 9600 | 19200 | 38400] − The serial bit rate
used to communicate with the management host.
auto_logout - The amount of time the Switch’s serial port can be idle
before automatically logging out. The possible values are:
never − There is no time limit on the length of time the console can
be open with no user input.
2_minutes − The console log outs the current user if there is no user
input for 2 minutes.
5_minutes − The console logs out the current user if there is no user
input for 5 minutes.
10_minutes − The console logs out the current user if there is no
user input for 10 minutes.
15_minutes − The console logs out the current user if there is no
user input for 15 minutes.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the baud rate:
DGS3100# config serial_port baud_rate 9600
Success.
DGS3100#
enable clipaging
Purpose To pause the scrolling of the console screen after each page when a
show command displays more than one page.
Syntax
enable clipaging
Description The enable clipaging command pauses the scrolling of the console
screen at the end of each page when issuing a command which
would display more than one screen of information. The default
setting is enabled.
Parameters None.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To enable pausing of the screen display when the show command output reaches the end of the page:
DGS3100# enable clipaging
Success.
DGS3100#